Drought FAQ
- Staff will immediately notify all non-exempt (non-domestic) use permittees of the declaration via email and US postal mail. These communications will contain information about curtailments, usage, and conservation practices. If a permittee needs a copy of their User Drought Contingency Plan and/or Drought Target Chart, please contact Regulatory Compliance staff at (512) 282-8441 or eswanson@bseacd.org.
- District website homepage and banner
- District Drought Information & Resources page
- Districts' social media channels: Facebook, Twitter, Instagram, LinkedIn
- Drought signs will be placed in many, but not all, neighborhoods known to be on exempt wells.
- 30% for Trinity and Alluvial/Austin Chalk Historical permittees
- 40% for Edwards Historical
- 50% for Edwards Conditional Class A permittees
- 100% for Edwards Conditional Class B permittees
- 100% for Edwards Conditional Class C and Class D permittees
- Conserve water and reduce your pumping rate to let your well recover. Certain aquifers are less permeable and more drought prone, and wells drilled into those aquifers can be low yielding and may take longer to recover or refill. Installing a water meter can also help you assess how much water you are using.
- Monitor and protect your pump. Low water levels can cause pumps to overheat and make your pump cycle on and off which can burn out the motor. If your pump is rapidly cycling on and off, turn it off. Installing an automatic low-flow shutoff switch, or a pump saver, can also protect your pump.
- Add a water storage tank if you have low or fluctuating yield. Adding a storage tank will help meet peak demand and help you maintain a steady water supply. It can also help extend the life of your pump, help dissipate sulfur odors, and settle any sediment.
- If your pump sounds like it is sucking air, let it rest. Indications that your well may be experiencing problems due to declining water levels and drought include a drop in water pressure, the well may begin to produce sediment and/or air bubbles, and you may notice “dirty” or milky looking tap water that clears after a short time.
- Getting more water will depend on your well. First, we recommend contacting your water well driller or pump installer. If you do not have a water well company you work with already, you can find one on our list of the companies that have with the District here. Once they have evaluated your well, they can provide an assessment of what the options are for getting you more water out of your well. Options may include:
- Lowering the pump. Usually the well is not dry, but the water level has declined below the pump and the pump needs to be lowered. In most cases getting more water could be as simple as having your well company set the pump lower in the well column so it is low enough to remain in water during times of drought. A driller or pump installer can help determine if the well is deeper than where the pump is set and if lowering the pump will address the issue.
- Deepening your existing well or drilling a new, deeper well. If it is determined your pump cannot be lowered and you are interested in deepening your well or drilling a new well, you should contact your well driller. It is important to note that deepening of your well may not be practical depending on the condition of your well.
- Installing a storage tank and hauling water until the drought ends.
- Rainwater harvesting so that you have an alternative supply when drought occurs.